What is the maximum garden size this tractor lawn mower is able to take care ?
STIGA Swift can cover up to 2,000sqm on one single charge. When you select the Eco-mode you can save up to 40% energy mowing up to 2,800 sqm on a single charge.
How many batteries are needed for this battery riding tractor?
This lawn tractor has 4 ePower batteries included. These are sharebale batteries that can be used with STIGA 5, 7 and 9 Series garden tools. You can keep on you gardening activities since Swift continues mowing with three batteries and keeps driving with only two.
How can I choose the best cutting mode for my grass condition?
From the dashboard you can choose between three different cutting modes:
1) ECO - for least demanding cutting conditions and very frequent cuts, low grass, soft, not too thick;
2) STANDARD - for usual, weekly cutting sessions (up to 2.5 cm) on both soft and hard grass;
3) BOOST - for more demanding cutting conditions, either quicker cut or harder, thicker, taller grass
Is it possible to connect the lawn mower tractor with my smartphone?
Yes, you can use your smartphone as a dashboard while driving, thanks to the STIGA.GO App! Download it and see real-time information about the working session: speed, battery charge left, but also a feedback from the machine on cutting efficiency, so you can adjust either speed or cutting height and achieve the best cutting results.
What is included in the box?
The STIGA Swift box includes the ride-on mower, four 48V ePower batteries, a single standard battery charger (plug-in) and an external dual fast charger. Mulching kit and trailer hitch are sold separately.
What is the proper way to clean the machine after mowing the grass?
The exterior of the machine must be cleaned with water and detergent, paying attention not to get water in the electrical system, motor and circuit board located under the instrument panel. The collection bag should be emptied and cleaned of residue, then remounted so the cutting assembly can be washed, and then removed, rinsed and allowed to dry. When washing the cutting device assembly and the expulsion chute, the collection bag or rear discharge shield must be fitted, the operator must be seated, the cutting device assembly must be in position “1”. Then connect a water hose to the appropriate pipe fittings and allow the water to flow for a few minutes while keeping the cutting devices in motion.